* Alarm Indicator for dry running, over-voltage, overload and over-temperature. IO 351 The IO 351 is a module for exchange of digital. The CU 352 has application-optimised software for adapting the system to the application in question. The control panel enables manual setting and change of parameters such as setpoint. The system monitor display on the CU200 shows the following: The CU 352 features a colour display, ten buttons and two indicator lights. The CU200 will allow you to add a float switch to shut off the pump when the storage tank is full. The CU 200 controller and system monitor can be used with solar alone or in combination with the IO101 (for manual generator backup). It is possible to start, stop and reset the pump by means of the on/off button. This is called mains borne signalling (or Power Line Communication), and this principle means that no extra cables between the CU 200 and the pump are required. Ĭommunication between the CU 200 and the pump takes place via the pump power supply cable. The CU 200 incorporates cable entries for. The CU 200 control unit is a combined status, control and communication unit especially developed for the SQFlex system. Built-in diagnostics indicate faults and dry-running, display operating status power consumption and level switch input. DescriptionGrundfos CU 200 SQFlex Control UnitĪ user-friendly interface box that maintains two-way communication with the pump and monitors the operating conditions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |